Mateksys ExpressLRS 2.4G PWM Receiver 6PWM
Perfect for Gliders, Plane, and FPV Wing pilots, the ELRS-R24-P6 provides a 6xPWM output ExpressLRS receiver for use without a FC
$29.99
or 6 weekly interest free payments of NZD $4.99 with
Hurry! Only 3 left in stock
Description
Perfect for Gliders, Plane, and FPV Wing pilots, the ELRS-R24-P6 provides a 6xPWM output ExpressLRS receiver for use without a FC
Note this is ExpressLRS v3.0 not compatible with your V2.4 gear.
ELRS-R24-P6 Specifications
- ESP8285, SX1281
- Antenna connector: IPEX MHF 1
- 6x PWM outputs
- Support 2~8S VBat voltage sense
- RF Frequency: 2.4GHz (2400~2480MHz)
- Telemetry power: 12dbm
- Receiver output protocol: PWM
- Input voltage: 4~9V DC @ “+” pad
- Voltage sense: 34V Max. @ “VBat” pad
- Power dissipation: 45mA(binding), 85mA(wifi mode)
- PCB size: 20mm x 18mm
- Weight: 2g w/ antenna
- Packing:
- 1x ELRS-R24-P6
- 1x IPEX MHF1 Antennas. 15cm
- Dupont 2.54 pins (Board is shipped unsoldered)
Firmwares
- ExpressLRS 3.0 or newer, DIY 2.4 GHz / DIY 2400 RX PWMP EX
- ExpressLRS wiki for PWM receiver, Click HERE
- Make sure Receiver and TX module both are running ExpressLRS 3.0 or newer
Receiver has ExpressLRS 3.0 preloaded with binding phrase “123456”, the Receiver will never enter binding mode if using the traditional binding procedure.
You need to reflash it with your binding phrase OR go into WebUI to set your binding phrase.
Flashing via Wifi
- Disconnect ESC and servos from receiver first.
- Power on receiver by 5V source. Receiver’s LED(Red) will blink slow at first, and after 20s, it should blink fast indicating it’s on Wifi Hotspot Mode.
- More detailed steps, pls refer this page.
- Target: DIY 2.4 GHz / DIY 2400 RX PWMP EX
Flashing via UART
- Disconnect ESC and servos from receiver first.
- Wire the receiver into the USB-TTL adapter, with TX on receiver connected to the Rx on the USB-TTL, and RX on receiver connected to the Tx of the USB-TTL. Wire 5V and GND of the USB-TTL to 5V and GND of the Receiver.
- Press the boot button while powering on the receiver, then release – the Red LED on receiver should now be solid.
- Select the target DIY 2.4 GHz / DIY 2400 RX PWMP EX and “UART” for Flashing Method, set your bind phrase and Firmware Options and once done, click on Build and Flash.
Additional information
Brand | |
---|---|
Protocol |
6 reviews for Mateksys ExpressLRS 2.4G PWM Receiver 6PWM
Only logged in customers who have purchased this product may leave a review.
Related products
-
TBS Tracer Micro TX Starter Set
4.00 out of 5(6) $224.99Out of stockRead more -
TBS Tracer Nano Receiver
5.00 out of 5(11) $57.99In stockAdd to cart -
HappyModel TCXO ExpressLRS 2.4GHz EP1 Nano Receiver ELRS
4.83 out of 5(46) $29.99In stockAdd to cart -
TBS Shrink Tubes (38 x 31mm)
5.00 out of 5(8) $2.99In stockAdd to cart -
TBS Crossfire Nano RX
4.92 out of 5(38) $52.99In stockAdd to cart -
HappyModel TCXO ExpressLRS EPW6 2.4GHz 6CH PWM Receiver
5.00 out of 5(1) $31.99In stockAdd to cart
Explore more from Mateksys
-
Mateksys RC Helicopter Flybarless Controller G474-HELI
5.00 out of 5(1) $94.99Out of stockRead more -
Mateksys F405-WING-V2 Flight Controller
$109.99In stockAdd to cart -
Mateksys 2812 6-LED Board (Qty 4)
5.00 out of 5(1) $11.99In stockAdd to cart -
Mateksys 2812 4-LED Board (Qty 4)
5.00 out of 5(3) $10.49In stockAdd to cart -
Mateksys 2812 LED Controller V2
5.00 out of 5(1) $13.99In stockAdd to cart -
Mateksys Crossfire to PWM Converter CRSF-PWM-V10
5.00 out of 5(1) $18.99In stockAdd to cart
Other products in the collection ExpressLRS
-
Happymodel Moxon 2.4GHz antenna for ExpressLRS TX module SMA
$14.99In stockAdd to cart -
RadioMaster ExpressLRS UART Firmware flashing Dongle
4.00 out of 5(1) $24.99In stockAdd to cart -
Happymodel 2.4GHz Antenna for ExpressLRS EP1 RX compatible with TBS Tracer
5.00 out of 5(5) $7.49In stockSelect options -
BetaFPV ExpressLRS Recovery Dongle
5.00 out of 5(3) $13.99Out of stockRead more -
HappyModel TCXO ExpressLRS EPW6 2.4GHz 6CH PWM Receiver
5.00 out of 5(1) $31.99In stockAdd to cart -
Mateksys ExpressLRS 2.4G Diversity Receiver
4.89 out of 5(9) $36.99In stockAdd to cart
Other ExpressLRS you might like
-
Happymodel 80mm 2.4GHz Antenna for ExpressLRS TX module SMA
5.00 out of 5(2) $9.99In stockAdd to cart -
HappyModel EP82 VRX Backpack Module
5.00 out of 5(1) $9.99In stockAdd to cart -
RadioMaster Ranger Micro 2.4GHz ExpressLRS Module
5.00 out of 5(5) $84.99Out of stockRead more -
BetaFPV ExpressLRS Recovery Dongle
5.00 out of 5(3) $13.99Out of stockRead more -
HappyModel TCXO ExpressLRS 2.4GHz EP1 Nano Receiver ELRS
4.83 out of 5(46) $29.99In stockAdd to cart -
Happymodel Moxon 2.4GHz antenna for ExpressLRS TX module SMA
$14.99In stockAdd to cart
Other Receivers you might like
-
RadioMaster UFL 2.4Ghz T Antenna for ELRS Receivers (65mm/95mm)
$9.99In stockSelect options -
RadioMaster RP4TD ExpressLRS 2.4ghz Diversity Nano Receiver
$49.99In stockAdd to cart -
HappyModel 2.4GHz EP1 Dual TCXO True Diversity ExpressLRS Receiver
5.00 out of 5(9) $44.99In stockAdd to cart -
TBS Crossfire Nano Diversity RX Adapter
5.00 out of 5(1) $9.49In stockAdd to cart -
Sale!
RadioMaster ER5A 2.4GHz 5Ch ELRS PWM Receiver
5.00 out of 5(2)$42.99Original price was: $42.99.$29.99Current price is: $29.99.In stockAdd to cart -
TBS Tracer Nano Receiver
5.00 out of 5(11) $57.99In stockAdd to cart
Other Wings you might like
-
Gemfan 9060R Glass Fiber Nylon 9x6R (CW) Electric Propeller (Pair)
$5.99In stockAdd to cart -
HQProp Thin Electric Propeller TE 9×5 CCW
5.00 out of 5(2) $7.49Out of stockRead more -
EMAX ES0803M Servo Horn Set & Screws
5.00 out of 5(2) $4.99In stockAdd to cart -
AtomRC Swordfish Wing Parts (14 Options)
5.00 out of 5(1) $12.99 – $79.99In stockSelect options -
Gemfan 6040R Glass Fiber Nylon 6x4R Electric Propeller (Pair)
$4.49In stockAdd to cart -
Gemfan 8040 Glass Fiber Nylon 8×4 Electric Propeller (Pair)
5.00 out of 5(2) $5.79In stockAdd to cart
Simon (verified owner) –
Nice
Will (verified owner) –
Excellent price. Be aware if your new to FPV stuff, the embedded systems are far more complicated than traditional receivers so make sure you aske for help from someone in the know. Plenty of support for the product online though. Fantastic customer service. Will be purchasing from the store again!
Anonymous (verified owner) –
Anonymous (verified owner) –
Jac C. (verified owner) –
Nice small ELRS PWM receiver. Only gripe is it uses generic firmware rather than Matek specific. Was a little confusing to update the firmware cause of this. Also works well as a crfs mode receiver if you want flexibility
Graham (verified owner) –