iFlight SucceX-D F7 V2.2 Stack F722 50A ESC w/ DJI

Description

The SucceX-D F7 is designed to work seamlessly with DJI’s HD FPV system. To make things even simpler, the DJI Air unit can just be plugged into the FC with the included wire harness. In addition, we added the popular and reliable USB Type-C instead of Micro USB and therefore the same standard than your DJI module.

Features

• Universal USB Type C connector instead of micro USB
• Plug-and-Play. No need to solder tiny wires.)
• Supports BLHeli pass-through for easy ESC upgrade and configuration.
• Designed to support DJI Digital FPV.

FC // SucceX-D F7 V2.2 TwinG

• MCU: 216MHz STM32F722
• Gyro：2x ICM20689
• Baro: DPS310
• Blackbox：32MB
• Betaflight OSD: YES
• BEC: 5V 2.5A / 9V 2.5A
• Current sensor scale: 100
• Inverter for SBUS input (UART2-RX)
• Smartaudio & Tramp VTX protocol supported
• Beeper pad : Yes
• RSSI input pad: No
• UARTs：5
• Motor outputs: 8
• 8 pin 4in1 ESC port (GND, VBAT, M1, M2, M3, M4, CUR, R5)
• 6 pin DJI Air Unit port (R1, GND, R2, T2, GND, 9V)
• BLHeli32 Telemetry：RX5
• Input voltage：recommended 2-6S, MAX 8S
• Firmware Target: IFLIGHT_F722_TWING
• Mounting pattern: 30.5*30.5mm φ4mm with Grommets φ3mm
• Dimensions: 36*36mm
• Weight: 9.1g
• USB type-C

ESC // SucceX 50A

Features:

• – 8 layers single-board stacking PCB board
• – 4oz 1.6mm thick power board
• – 32bit G071 MCU, 48mHz maximum clock speed;
• – TDK MLCC Low ESR ceramic capacitors;
• – Top grade NTMFS5C430NL MOSFET;
• – Rational layout, countersunk holes on extended solder pads to ensure PCB layer connection

Specification:

• MCU: STM32G071
• Up tp 48kHz PWM frequency
• Capacitance: 470uF/50V
• Current Sensor: Yes
• Input: 2-6S LIPO
• Constant: 50A / Burst: 60A
• BlHeli32 telemetry: Yes
• BEC: No
• Supports up to Dshot600, Proshot, Oneshot, Multishot
• Target: iFlight_G071_4in1
• Weight:14.3g
• Mounting pattern: 30.5*30.5mm/Φ3mm
• Dimensions: 43*39mm (including the power pads)

Package included:

• SucceX-D F7 TwinG FC x 1
• SucceX 50A V2 ESC x 1