Drone Frames>Frame Accessories

Foam-Cure EPP and EPO Foam Bonding Glue 100ml

Foam safe glue for securing electronics and minor repairs. Low viscosity (gel) type glue for easy application.

$13.99

or 6 weekly interest free payments of NZD $2.33 with

In Stock at KiwiQuads

Ships from our Auckland warehouse

Description

The Foam-Cure EPP and EPO Foam Bonding Glue is the recommended glue to be used on your RC airplane or wing.

Foam cure is a silicone based adhesive that works very well on EPP and EPO foams. It is crystal clear and cures to a more flexible consistency than CA. It is, however, not instant bonding like CA and there is no accelerator to speed it’s curing. To obtain a faster initial bond when bonding two pieces, Foam cure can be applied to one piece and after the two are joined, they can then be pulled apart. After letting it air dry for about 5-6 minutes, foam cure will act like a contact cement when the parts are rejoined, resulting in enough tack strength to allow the next steps of assembly. Full strength is reached in 10-12 hours.
Foam cure works with all foams, and will actually bond most other materials. It will bond wood and plastic to foam, and is a good canopy glue. Foam cure does not, however, cure flexible enough to act as a hinge for aircraft control surfaces. Its limitations occur when bonding large areas of two non-porous materials. Foam cure requires exposure to air for drying. If one tried to bond, for example, a half-dollar coin to glass, over 90% of the adhesive would never cure, since the solvent it contains would have no where to evaporate.

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.